Topic: effect level automation

Viewing 5 posts - 1 through 5 (of 5 total)
  • October 11, 2010 at 18:08 #2403
    Divintek
    Participant

    i’m here again. 🙁 I added a reverb to a track, and i need to know if it is possible to automate the reverb level to make it “appear” with the automation. The only automable parameter is “Level” but this is kind of the entire track volume level: infact when it is to minimum i hear no sound, and i wanted the only reverb effect be “mute” instead and appear with the automation. help. XD

    October 11, 2010 at 21:07 #19635
    Luciano
    Participant

    Are you using a vst effect or zreverb? Perhaps mix or dry/wet a parameter

    October 11, 2010 at 23:16 #19636
    Divintek
    Participant

    Yes, you’re right, that would be one way. i’m using zreverb, but i really need to have an automation for the effect level. In other DAWs, when you assign an effect to a track, you also have a knob that can be moved from 0 to maximum for the amount of the effect on the track. i hoped to be clear.

    October 12, 2010 at 06:43 #19638
    ronin
    Participant

    You can do that. Take a look at the Podium User Guide. There is a paragraph in the “Getting Started” chapter about that (english version).

    October 12, 2010 at 07:04 #19639
    bacon
    Participant

    Have you inserted the reverb in the track itself? Reverb is ususally better to have as a bus effect. Add a send to the instrument/audio track and put the reverb on the bus that’s connected to the send. You can then automate the send level to get the result you’re after.

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.
© 2021 Zynewave