Topic: zPitch default value

Viewing 3 posts - 1 through 3 (of 3 total)
  • August 8, 2009 at 20:26 #2009
    thcilnnahoj
    Participant

    I read in the Guide that curve event points can be reset by holding ALT: “Use this to reset for example pitch bend or pan parameter curves to their center position.”

    Would it be possible to update zPitch so the default value for its pitch parameter corresponds to no pitch change? Right now it defaults to zero, meaning -12 semitones.

    Seems it can be done by the user (by changing the parameter properties for ‘pitch’ in the inspector param tab) but of course I only found out about that now. Anyway, zero cents would make for a better default than -1200 for everyone, I think.

    By the way (not via PM this time :wink:), the help for all three draw mode buttons in the curve editor says to hold CTRL to reset instead of ALT (Podium 2.19).

    August 16, 2009 at 01:05 #16132
    Zynewave
    Keymaster

    @thcilnnahoj wrote:

    I read in the Guide that curve event points can be reset by holding ALT: “Use this to reset for example pitch bend or pan parameter curves to their center position.”

    Would it be possible to update zPitch so the default value for its pitch parameter corresponds to no pitch change? Right now it defaults to zero, meaning -12 semitones.

    Seems it can be done by the user (by changing the parameter properties for ‘pitch’ in the inspector param tab) but of course I only found out about that now. Anyway, zero cents would make for a better default than -1200 for everyone, I think.

    Currently you’ll need to do it via the parameter properties dialog. In a future update I may update the zPitch plugin to support extended parameter info. I think that will make it possible for Podium to detect what the default value should be. But that is far into the future.

    By the way (not via PM this time :wink:), the help for all three draw mode buttons in the curve editor says to hold CTRL to reset instead of ALT (Podium 2.19).

    Fixed. Thanks.

    March 29, 2010 at 22:53 #17777
    Zynewave
    Keymaster

    This is implemented for the next 2.28 release. I didn’t change the zPitch plugin, as I suggested in the above post, but rather I shared the info from the integrated plugin editors. I had done some of this work earlier with the embedded rack/mixer editors, so it was easy to extend this to the curve editor and the mixer faders.

    It applies to all other Zynewave plugin parameters as well, such as the zPEQ gain parameters.

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.