Topic: Audio parameters doesn’t show in track inspector.

Viewing 3 posts - 1 through 3 (of 3 total)
  • October 7, 2005 at 19:45 #660
    Joachim
    Participant

    I created all device defintions, audio busses and so forth manually with the purpose of learning this exellent sequencer properly.
    In this project I’m currently working on, I realized I needed to automate the level of a mixer track.
    I created a new parameter (audio level) and though that was all there was to it, but no. I can’t seem to get this audio level parameter to appear in the track inspector. Same goes for panning and send level.

    How do I make these manually created audio parameters appear in the track inspector?

    /Joachim

    October 7, 2005 at 20:01 #5544
    Zynewave
    Keymaster

    The audio parameter must be placed within a device definition object. The definition object should then be selected in the properties of your master output mapping object. If in doubt, check how the level parameter is created by the wizard ‘create audio output mappings’ command.

    October 7, 2005 at 20:23 #5545
    Joachim
    Participant

    The definition object should then be selected in the properties of your master output mapping object

    That was the part I was missing! Got it working now 😀

    Thanks for super-quick reply. You rock! 8)

    /Joachim

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.
© 2021 Zynewave