Topic: Bug? Crash on startup when control surface is configured but not connected

Viewing 2 posts - 1 through 2 (of 2 total)
  • November 27, 2013 at 18:42 #25209
    aanto
    Participant

    Case: Config the control surface in Podium. Exit. Disconnect the device physically. Start Podium again, it may crash immediately after startup. Connect the device back. It runs ok again.

    Here’s the section from crash config. When I delete these lines Podium runs ok with device disconnected:

    [ControlSurface1]
InputInterfaceID="nanoKONTROL2 1 SLIDER/KNOB"
OutputInterfaceID="nanoKONTROL2 1 CTRL"
ChannelOffset=4

    Podium 3.2.1 x64, Win 8.

    December 1, 2013 at 02:07 #25224
    Zynewave
    Keymaster

    Thanks for the bug report. I couldn’t provoke a crash on my machine, but I did find an issue with initialization of disconnected USB MIDI devices. I have uploaded a 3.2.2 beta with a fix on the My Downloads page. If you find the time to test this beta, please report whether the crash bug is gone.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.
© 2021 Zynewave