Nick Mason's Forum Page

Profile  |  Topics  |  Replies  |  Favorites

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • in reply to: Overload!!! Podium can't keep up? #40517
    Nick Mason
    Participant

    Hi

    Thanks for your reply.

    The stuttering and cut outs usually occur toward the end of a three minute track. It usually happens just once per track.

    I’m fairly sure I have selected the right driver when recording.

    I have tried the audio buffer setting both higher and lower, and also altered the audio sample rate. but still the same problem.

    Are there any other settings that I could try?

    kind regards

    Nick

    Nick Mason
    Participant

    Hi

    Thanks for the reply.

    I’m recording audio rather than midi, so I don’t think that’s the problem.
    It only started recently, my first half dozen tracks were fine. Now it even does it on pieces with few notes in them.

    I get two minutes in and everything is perfect and then it suddenly it looses a second or two of sound.

    in reply to: CAN'T USE PUNCH IN, HELP!!! #40449
    Nick Mason
    Participant

    Hi

    Thanks for your reply.

    It’s good to know I hadn’t been doing anything wrong. I suppose the paid version doesn’t have this limitation?

    I may give the two track approach a try.

    cheers

    Nick

    in reply to: Overload!!! Podium can't keep up? #40448
    Nick Mason
    Participant

    Unfortunately this problem has recurred. After recording a longish piece with a lot of notes, I get
    stuttering sounds and sometimes a blank bit, often towards the end of the piece.
    I have tried turning down the gain (so there is less information going in), and reducing the sample rate but these things haven’t been effective.
    Any ideas would be gratefully received.

    Ta,

    Nick

    in reply to: Overload!!! Podium can't keep up? #40364
    Nick Mason
    Participant

    Hi John

    Thanks for your reply.

    By adaptor do you mean USB interface? I am recording from a keyboard via 1/4inch jack to a Alesis USB unit. I realised that I had the gain on the unit quite high so turned it down and upped the input volume instead, that seems to have done the trick so far. The next step is doing a decent rendition of the piece, which is easier said than done!

    Nick

Viewing 5 posts - 1 through 5 (of 5 total)
© 2021 Zynewave